• Product type: Wash
• Works with: Cleani
• Power: 110 V — confirm your supply before ordering
• Tanks: dual 4 L
• Cycle: up to 90% resin removed in 6 min
• Presets: 3 / 5 / 10 min

What resins will it print? ACKURETTA runs an open but validated system. The printers cure 385–405 nm photosensitive resin, and ACKURETTA publish pre-calibrated profiles rather than leaving you to guess settings.

Brands on ACKURETTA's own published compatibility list: CURO (ACKURETTA's own line — Element Model, Ortho Model, Pro Denture, Guide, Crown), VOCO (V-Print), Argen (Model Beige, Light Grey), Rodin (Sculpture, TruModel), Optiprint (laviva, guide, lumina), KeyModel Ultra (Keystone), Mack4D and FLOW (Denture, Hard Splint, C&B). ACKURETTA additionally list BEGO and Pac-Dent among validated partners.

Validated applications: dental models, orthodontic models, surgical guides, splints and night guards, denture bases and teeth, temporary crown & bridge, and permanent restorations on the ceramic-filled materials.

The honest limitation: open does not mean any bottle works. ACKURETTA validate each resin to hold accuracy, mechanical properties and biocompatibility, and state plainly that self-calibrated settings are not supported. The full per-platform list is in the compatibility PDF below — note that some resins are validated only for specific build platforms. Tell us the resin you intend to run and we will confirm it against your exact machine and platform before you order.

Figures published by ACKURETTA and its distributors. Throughput depends on layer height, resin and geometry — treat arch counts as manufacturer figures, not a guarantee for your case mix.

• ✓ Two-stage dual tank removes up to 90% of uncured resin in 6 minutes.
• ✓ Separating dirty and clean stages cuts alcohol consumption by roughly half.
• ✓ Vortex motion rather than ultrasonics — gentler on thin crown and guide margins.
• ✓ Hydrometer included; alcohol saturates invisibly and a saturated bath stops cleaning.
• ⚠ Alcohol is a consumable running cost and requires appropriate storage and ventilation.
• ⚠ Over-WASHING thin parts softens fine margins — longer is not better.

Pro tip — WASHING small prints

Pro tip — cleaning your EQUIPMENT

• CLEANIP PLUS High Volume WASHING Station for 3D Printing - 110v 1 year Warranty

Building a full workflow? Printer, WASHING station and CURING unit are sold separately and as bundles. Tell us your case volume and we will quote the combination that actually fits it.

• Separate dirty and clean stages; that is the point of the dual tank and it roughly halves alcohol use.
• Use the hydrometer — alcohol saturates invisibly and a saturated bath stops cleaning.
• Do not over-wash thin parts; excess solvent contact softens fine margins.

Build platforms, vats and print screens are model-specific. SOL and SOL Plus parts are not interchangeable, and this is the single most common ordering error on this range. Confirm which machine you run — the model is on the label at the back of the unit — or send us the serial number and we will confirm the correct part.

• 🗎 CLEANI — product flyer (PDF)

Documents hosted by ACKURETTA. Need the manual or resin list for a different model in the range? Ask us and we will send it.