VARSEO VarseoSmile Crown plus, B1, 250g - #41120 3D Resin

Hover on image to enlarge
9 item(s)
You save: $4.92 (2%)

Minimum quantity for "VARSEO VarseoSmile Crown plus, B1, 250g - #41120 3D Resin" is 1.

VarseoSmile Crown plus, B1, 250g
  • View all variations as list
Full range of Dental Supplies with incredible prices and outstanding customer service...
Ask a question
Sellers of this product

VarseoSmile CROWN PLUS

The tooth-colored ceramic filled hybrid material for 3D printing of permanent single crowns, inlays, onlays and veneers

Advantages for the laboratory

  • Specially for the resin developed printing and processing parameters ensure smooth production sequences with reproducible results at any time
  • High dimensional stability and strength of the printed objects due to high values of flexural strength and flexural modulus – therefore precise fit
  • Minimized resin sedimentation for easy handling, no mixing or shaking necessary with regular use
  • Easy to grind and polish by using standard tools
  • Seven shades according to the proven VITA* classical shades:
    A1, A2, A3, B1, B3, C2, D3
  • Satisfies all the requirements for a Class IIa** medical device

Advantages for the patient

  • Excellent aesthetics thanks to a balanced ratio of opacity and translucency
  • Low tendency to age and discolor thanks to very low water absorption
  • Low plaque accumilation due to smooth surface
  • High comfort thanks to low cold and heat sensitivity
  • Antagonist-friendly material with mechanical buffering effect – ideal for implant-supported crowns
  • Minimized formation of secondary caries thanks to a high adhesive bond with luting composites
  • High biocompatibility due to very low water solubility – therefore not cytotoxic, not genotoxic, not toxic, not irritating and not sensitizing

Individualization with stains

The individualization of the post-cured objects is possible with composite stains and is the responsibility of the user. Follow manufacturer‘s instructions.

Note for practitioners

VarseoSmile CROWN PLUS can be attached using self-adhesive cements (e. g. RelyX Unicem*, 3M Espe*) or composite cement with a primer (e. g. Variolink Esthetic DC* and Monobond PLUS*, Ivoclar Vivadent*). Observe the instructions for use of the luting agent.


The light polymerization can be achieved with the BEGO Otoflash (two xenon stroboscopic lamps, flash frequency 10 Hz, light spectrum 300 – 700 nm) or with the HiLite Power*, Fa. Heraeus Kulzer* (one xenon stroboscope lamp, flash frequency 20 Hz, light spectrum 390 – 540 nm).

Required light-curing time
Light-curing deviceLight-curingComments
BEGO Otoflash (with protective gas)2 × 1,500 flashesTurn object between the exposure cycles
HiLite Power2 × 90 seconds
Product details
ColorA1, A2, A3, B1, B3, C2, D3
Densityapprox. 1.4 – 1.5 g/cm³
Layer thickness50 ?m
Viscosity2,500 – 6,000 MPa*s
Flexural strength116 MPa
Flexural modulus4,090 MPa
Water solubility0.23 µg/mm³
Water sorption3.6 µg/mm³
Wavelength405 nm
Crown C&B
Manufacturer #:
.MPN #.41120

No posts found

Write a review

Similar products

This site uses cookies.

Some of these cookies are essential, while others help us to improve your experience by providing insights into how the site is being used.